top of page

The Carpenters Set is a great all-around tool belt suitable for many trades and has enough versatility to serve you well throughout most phases of construction from framing to finish work.


Our full sets are designed and built to increase your efficiency and keep you comfortable throughout your workday.


Badger dominant side bags are made to hold common hand tools and other necessary items.

Non-dominant bags have ample cargo space for fasteners, tape measures, assorted bars, chisels, speed squares and other common tools.


Available in Gunmetal Grey and Sawdust Sage

Tool side: 5 tool slots in the main pouch-three along the inside back and two inside front, single outside lower pouch with a tool slot, and a rear tool loop. Pencil/utility combo up front with three small slots and one deep pocket

Fastener side: 3 elastic nail set slots in tape pouch, speed square slot, lower tool slot, side by side outside pouches, slots in each fastener pouch, reinforced bar slot on the underside of the bag.

American-made foam, various military-grade tactical webbings designed to be both lightweight and abrasion-resistant, plastic and metal military hardware, and heavyweight military thread

1000 Denier CORDURA® Nylon fabric with water repellent coating

As with all Badger bags, the bottom of the main and fastener pouches are reinforced with USA-made tactical webbing to increase puncture and abrasion resistance.

Lightweight tough and built to last.

Made in the USA!

The Badger contoured belt measures 3.5" along the sides and rises to 5.5" for added support along the back.


To ensure you get the belt that will offer you the most flexibility, it’s important that you read and follow these instructions. DO NOT base your choice on your pants size. Take a string or tape measure and measure snugly where you plan to wear your tool belt. Belts are typically worn on the hips. This area tends to be wider than where your pants sit. For example, I wear a size 33” waist jeans. But I measure a 37” around my hips, where I like to wear my tool belt. Keep in mind your working conditions. If you work outside in all seasons, layers will increase your circumference.

Our belts have around four or five inches of flexibility for the best fit. This is more than enough for most people. For an optimal fit, there should be 2″ to a max of 6″ of open space between your belt ends. For instance, if your measurement is 36”, you should go with a MD belt which will leave about 3” of open space. Keep in mind, if you prefer your bags to sit further back, order on the small side. Hi

Badger Carpenter Toolbelt Set

    bottom of page