top of page

If you prefer a trimmed-down set, this rig will keep you organized while still providing an impressive amount of storage.


Designed and built to increase your efficiency and keep you comfortable throughout your workday.


It's a shortened version of our Carpenter's Set, with a single outer pouch on the fastener side, measuring 11"/ approx 33cm from top to bottom.


Available in Gunmetal Grey and Sawdust Sage

Tool Side: Five tool slots in the main pouch-three along the inside back and two inside front, single outside lower pouch with tool slot, rear tool loop. Pencil/utility combo upfront with three small slots and one deep pocket. Overall length is approximately 11"/ 33cm

Fastener side: Speed square slot, lower tool slot, side by side outside pouches, slots in each fastener pouch, reinforced bar slot on the underside of the bag. Overall length is approximately 11"/ 33cm

The Badger contoured belt measures 3.5" along the sides and rises to 5.5" for added support along the back.

American-made foam, various military-grade tactical webbings designed to be both lightweight and abrasion-resistant, plastic and metal military hardware, and heavyweight military thread

1000 Denier CORDURA® Nylon fabric with water repellent coating

As with all Badger bags, the bottom of the main and fastener pouches are reinforced with USA-made tactical webbing to increase puncture and abrasion resistance.

Lightweight tough and built to last.

Made in the USA!


To ensure you get the belt that will offer you the most flexibility, it’s important that you read and follow these instructions. DO NOT base your choice on your pants size. Take a string or tape measure and measure snugly where you plan to wear your tool belt. Belts are typically worn on the hips. This area tends to be wider than where your pants sit. For example, I wear a size 33” waist jeans. But I measure a 37” around my hips, where I like to wear my tool belt. Keep in mind your working conditions. If you work outside in all seasons, layers will increase your circumference.

Our belts have around four or five inches of flexibility for the best fit. This is more than enough for most people. For an optimal fit, there should be 2″ to a max of 6″ of open space between your belt ends. For instance, if your measurement is 36”, you should go with a MD belt which will leave about 3” of open space. Keep in mind, if you prefer your bags to sit further back, order on the small side.

Badger Trimmer Toolbelt Set

    bottom of page